Buffer Set Tables; Process Screens - ECOLAB Versatronic Betriebsanleitung

12.8.9

Buffer set tables

Three buffer set tables are created in Ecolab 'Versatronic' . Buffer set tables are required
for the calibration of pH sensors with automatic buffer recognition.
Ä Chapter 10.2.2 'Calibrating the pH measurement' on page 114.
See
You can change these buffer set tables here.
From the factory, the buffer set tables are assigned as follows:
n Buffer set 1: Reference buffer solutions for the calibration of the pH measuring
equipment according to DIN 19266
Buffer set 2: Technical buffer solutions, preferably for the calibration and adjustment
n
of technical pH measuring equipment according to DIN 19267
n Buffer set 3: No data
Go to settings:
Just Setup è Buffer set tables è Tab "Buffer set table 1 to 3"
Fig. 129: Buffer set tables

12.8.10 Process screens

Process pictures are images that can be created or edited individually depending on the
particular process. This is set up the Setup program and then sent to the device by means
of reconfiguration.
Components of the process pictures are:
n Background colour: Adjustable colour of the background, see Fig. 129, (2).
n Background: Any image in bitmap format (the size of the process picture is
316 × 182 pixels), see Fig. 129, (6).
n Objects: Graphical elements for visualizing the operating state of resources of a plant
(e.g. as pumps, valves, heaters, etc.), see Fig. 129 (3).
In the configuration, you can show/hide operating screens.
Check the setting of the process picture in the configuration.
Device menu
Settings (for process picture editor):
Just Setup è Process screens (double-click) è Tab "Process screen 1"
è Show è General è Show process screen
221
PC setup program
417102269 Rev. 2-08.2020