Binary Outputs - ECOLAB Versatronic Betriebsanleitung

10.4.9

Binary outputs

Go to: Device menu è Configuration è Binary outputs è Binary output 1 to 17
Configuration
item
Name
Output value
signal
Inversion
Manual mode
allowed
Selection / option
Up to 21 characters of text
Controller/
* Controller 1 Output 1
* Controller 1 Output 2
Dosing alarm controller 1
* Controller 2 Output 1
*Controller 2 Output 2
Dosing alarm controller 2
* Control 3 Output 1
Controller 3 output 2
Dosing alarm controller 3
* Controller 4 output 1
Controller 4 output 2
Dosing alarm controller 4
* = Please select only the highlighted points
Yes
No
Yes
No
Explanation
Output name
Binary signal source for the
output
Invert switching state or do
not invert
Here, the manual mode for
the corresponding output is
disabled/enabled.
With manual mode you can
set the fixed binary values
(switching states) for the
purpose of testing the output.
See Ä Chapter
10.6 'Functional level'
on page 179.
167
Device menu
Default
OUT 1: Controller 1 Output
1
OUT 2: Controller 2 Output
1OUT 12: Controller 3
Output 1
OUT 13: Controller 4 Output
1
OUT 14: Controller 1 Output
2
OUT 15: Controller 2 Output
2
OUT 1: Controller 1 Output
1
OUT 2: Controller 2 Output
1OUT 12: Controller 3
Output 1
OUT 13: Controller 4 Output
1
OUT 14: Controller 1 Output
2
OUT 15: Controller 2 Output
2
No
Yes
417102269 Rev. 2-08.2020