Configuring The Connection Without The Assistant - ECOLAB Versatronic Betriebsanleitung

PC setup program
Setup dialogue - Summary of Settings
To complete the configuration, the user gets an overview of the settings.
An erroneous setting can be corrected by the user calling up the right setup dialogue
again by clicking the "Back" and then making the correction.
Fig. 109: Setup dialogue - Summary of Settings
After clicking on "Finish" the assistant is finished and the new connection in the device
connection list is registered.
12.7.3

Configuring the connection without the assistant

The assistant can be disabled in the device connection list (remove check).
See Fig. 102.
Unlike with the active assistant, you are not led through the steps but have to select the
individual configuration steps yourself. The following example shows the basic procedure.
The parameters in the individual setup dialogues are mostly the same as in the
configuration with assistant, so that here description is omitted.
However, in the settings for establishing communication other protocols and interfaces are
available.
The configuration of a new connection "without assistant" requires expert
knowledge and is only intended for service purposes.
417102269 Rev. 2-08.2020 204