Data Transfer Menu - ECOLAB Versatronic Betriebsanleitung

PC setup program
12.6.2

Data transfer menu

Connect ...
Opens the device connection list. The contents of the device connection list depends on
the project. The device connection list shows devices to which a link can be established
with the setup program. Devices can be added to the list or removed from the list. In the
device connection list, you can also make the connection settings.
Ä Chapter 12.7.2 'Configuring the connection with assistant' on page 200.
See
Disconnect ...
Ends all connections of the active project, i.e. the selected setup file.
Data transfer to device ...
Sends the setup data to the device. Previous connection to the device.
If there is no connection, the device connection list opens automatically.
Data transfer from device ...
Exports the configuration from the device. Previous connection to the device.
If there is no connection, the device connection list opens automatically.
Data transfer to external storage. Storage ...
Exports the setup file in the SET format to an external storage (USB flash drive).
This file can be loaded via the USB port on the device directly into the device.
Data transfer from external storage. Storage ...
Imports a setup file in the SET format from an external mass storage devices (USB flash
drive) into the open setup file. A SET file that was previously copied to a USB memory
drive from the machine can be opened for editing with the Ecolab PC Setup program.
For information about loading and saving SET files via the USB port on the device:
Ä Chapter 9.3 'Storage management (USB flash drive)' on page 91.
See
417102269 Rev. 2-08.2020 196