Pipe Mounting - ECOLAB Versatronic Betriebsanleitung

Assembly
6.3

Pipe mounting

For pipe-mounting the optional pipe assembly set is needed.
There is also a protective housing available.
Fig. 8: Pipe mounting
1 Pipe / pole (onsite) with a diameter of 35 to 55 mm
2 Self-drilling screws 60 × 16 TORX PLUS®a 30IP
(delivered with Ecolab 'Versatronic' )
3 Pipe clamps from the pipe assembly set
Procedure
1. Screw in the mounting plate (4) and the protective roof (if applicable) (6) with the
screws (2) to the rear of the device (5).
2. Insert the two pipe clamps (3) through the slots of the holding tabs on the mounting
plate (4) as shown in the drawing.
3. Place the device on the pipe/mast (1) so that the pipe clamps (3) enclose the tube,
close the clamps (3) and tighten.
417102269 Rev. 2-08.2020
4 Mounting plate for pipe installation from the pipe
assembly set
5 Ecolab 'Versatronic'
6 Canopy made of stainless steel 1.4301
46