Setting The Date And Time; Setting Staff Codes; Setting The Access Code For The Programming Level - ECOLAB DG 3.1 Betriebsanleitung

8.4.8

Setting the Date and Time

You normally only have to set the date and time once. Even if the power goes off, the buffer
battery ensures that there is no interruption to the time and date.
 Setting the date and time
(Also refer to chapter
Format of date:
dd.mm.yy
 Saving the new values set
8.4.9

Setting Staff Codes

You can program up to 15 different 2-digit staff codes.
 Setting/activating the staff code:
(Also refer to chapter
Staff No.
(1...15)
 Saving the new values set
8.4.10

Setting the Access Code for the Programming Level

The access code for the programming level should only be known to the group of people
with responsibility for the DG3. The operating personnel should only know the staff code if
this is required and activated.
The delivery status for the access code is 1234.
This can be changed to suit the user's own wishes.
 Setting/activating the access code.
(Also refer to chapter
 The following display has to be selected:
 Saving the new values set
417102242_DG_3
8.2 "Programming Structure" and
Fig. 8.45 Setting the date and time
8.2 "Programming Structure" and
Fig. 8.46 Setting Personnel Codes
8.2 "Programming Structure" and
Fig. 8.47 Setting the Access Code for the Programming Level
- 81 -
8.4.1 "Operation Handling").
Automatic summer/winter
time switchover
8.4.1 "Operation Handling").
Staff code associated with
the staff No. (-- = deactive)
8.4.1 "Operation Handling").
Access code
Rev.: 02-05.2014