Timing Diagram; Time Switch; Timer - ECOLAB Versatronic Betriebsanleitung

Configuration
point
Signal tolerance
band w
Window width
( 1 ) The unit for the window width comes from the parameter "Signal tolerance band x" in this table.

Timing diagram

Fig. 88: Timing diagram
1 Follow-up time timer
2 Output signal
3 Signal for timer start
4 Lead time Timer start
5 Timer time

10.4.10.2 Time switch

Timer settings for a weekly scheduling program
Requirement: The "Timer function" must be configured as a "timer".
For each day of the week, you can set up to 4 ON and OFF times.
Call switching time settings:
Device menu è Configuration è Timer è Timer 1 to 2 è Zeitschalter è Monday to
Sunday
Configuration item
Timer function:
Switch time 1 to 4
Off times 1 to 4
Selection / option
Select from analogue sector Selection of the analogue signal, for
0 to 99999 ( 1 )
Selection /
settings Explanation

Timer

Weekly timer function:
Time switch up to 4 adjustable switch-on and off times per week
Time switch with
runtime
hh:mm:ss If the switch-on time is exceeded, the timer is set to
binary value = 1 (ON).
hh:mm:ss Once the time for the switch-off is exceeded, the
timer is set to binary value = 0 (off).
169
Explanation
which the signal "tolerance band x"
must not be more than the "window
width" deviate so that the timer can
run
Maximum amount of deviation
| X - w |
6 Follow-up time, timer end
7 Lead time Timer start
8 Timer time
9 Follow-up time, timer end
Device menu
Default
No selection
0.0000
Default
Time switch
00:00:00
00:00:00
417102269 Rev. 2-08.2020