Commissioning; Initial Start-Up; Functional Test - ECOLAB Versatronic Betriebsanleitung

Commissioning

8 Commissioning
Personnel:
WARNING!
In the beginning, make sure that the unit is properly mounted and
connected in compliance with the assembly instructions.
Follow the safety instructions in this description.
CAUTION!
The touchscreen must not be operated with sharp or pointed objects, since
they can damage the protective film and the touchscreen.
8.1

Initial start-up

1. Turn on the power supply of the device and wait for it to boot up.
2. Select the operating language.
3. Log on as an "operator" or "master" in order to gain access to the following menu
items. See
4. Make the settings for date and time.
Ä Chapter 10.5.1 'Date and time' on page 176
5. Make the necessary basic settings at user level.
Ä Chapter 10.3 'User level' on page 136.
See
6. If one or more controls are enabled on the user level, set at the parameter level
controller parameters and setpoints.
Ä Chapter 10.5.2 'Parameter sets (controller parameters)' on page 176,
Ä Chapter 10.5.3 'Setpoints' on page 178
7. Check the hardware features of the device.
Ä Chapter 8.2 'Functional test' on page 76
8. The device is now ready for operation.
8.2

Functional test

"Device Info" contains important hardware information.
From here, the functionality of the device can be tested.
417102269 Rev. 2-08.2020
n Manufacturer
n Mechanic
n Qualified electrician
n Service personnel
n Specialist
Ä Chapter 10.1 'Login / logout' on page 106
76