Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
4.5.1
Connection of hose
Note data on the in-pack notelet with the hose connecting elements!
n
Cut the hose (
angles.
n
Slip the union nut (pos. 2) and clamping element (Pos. 3) over the hose.
n
Slip the hose onto the cone (pos. 4) up to the stop collar.
n
Position the O-ring seal (pos. 5) into the groove provided on the connecting adapter
(pos. 6).
n
Connect the hose and cone (pos. 4) and tighten the union nut (pos. 2).
4.5.2
Connection of pipe
n
Cut the pipe (
angles.
n
Slip the union nut (pos. 2) over the pipe.
n
Weld / adhesive bond the insert (pos. 3a) to the pipe.
n
Position the O-ring seal (pos. 5) in the groove provided on the connecting adapter
(pos. 6).
Tighten the union nut (pos. 2).
n
4.6
Electrical connection
PLUS
The OGM
Electrical connection is accomplished by means of a four-pole M12 connector.
4.6.1
Connection to (SPS) control systems
The OGM
reprogrammed to NPN output if required.
If you use your own PLC cable instead of our prefabricated PLC cable, it is
imperative that a bridge is placed in the connector between PIN 3 and 2.
If this bridge is not present, malfunctions / failures may occur.
417102601 Rev. 1-12.2019
Ä Chapter 4.5 'Installation of hose or pipe' on page 11, pos. 1) at right
Ä Chapter 4.5 'Installation of hose or pipe' on page 11, pos. 1a) at right
electronic evaluation system is moulded into the cover.
PLUS
is supplied with PNP output. However, it can be
12
Werbung
Inhaltsverzeichnis
