B) Setting Of Servo Rotating Direction (Rev) - Reely 23 15 52 Bedienungsanleitung

b) Setting of servo rotating direction (REV)

Depending on the location of the installation and the linkage in the model, it may be necessary to
change the rotary direction of one servo and therefore the functional direction of the corresponding
controls on the remote control.
When you are turning the steering wheel on the transmitter (see illustr. 1, pos. 2) towards the left but
the vehicle makes a turns right, the reverse function for the steering servo (channel 1) has to be acti-
vated.
For this purpose, proceed as follows:
• Switch the transmitter on. On the transmitter's LC dis-
play the operating display will appear.
• Now press the menu select button SEL (see illustration
2, pos. 4) 2 x.
On the left edge of the display REV (reverse) will appear
and on the top right the channel 1(CH 1) for the steering
is shown.
Depending on the programming, the display can now
show "OFF" for the normal driving direction or "REV"
for reversed driving direction.
• With the two setting buttons (see illustration 1, pos. 6)
you can now set the desired driving direction.
• With the channel shift key (see illustration 1, pos. 5) you
can change to throttle servo (channel 2) and also set
the correct driving direction for the throttle servo if nec-
essary (see also illustration 6, pos. 1).
• The value set last is always automatically saved.
50
REV
REV
REV
CH
CH
CH
Illustration 8