Getting Started With The Model Vehicle; A) Connecting Drive Battery - Reely RHINO Bedienungsanleitung


9. Getting Started

with the Model Vehicle

a) Connecting drive battery

Before connecting the drive battery with the cruise control, start using the remote control transmitter
and check the function of the transmitter in accordance with the instructions for use.
To prevent a sudden starting of the wheels and there-
fore an uncontrolled starting of the model, place the
model vehicle on a suitable wooden block (1) or simi-
lar, so that the wheels can turn freely in case there
is a fault scenario.
Now connect the drive battery with the cruise con-
trol with the help of the plug (2) that is protected
against polarity reversal.
Slide the cruise control switch (if it exists) in the "ON" position and check the drive and steering func-
tions as well as the necessary trim values of your vehicle in accordance with the instructions of the
operating instructions of the remote control.
If the electric motor does not stop when the operating lever for the drive function is in the
centre position, the servo path on the transmitter has to be programmed on the mechani-
cal cruise control and/or the steering rods have to be changed.
When using an electronic cruise control, the cruise control has to be programmed.
Illustration 12
41