Selection Of "Fast" Exposure (10 S - 20 S); Selection Of "Slow Rise" Exposure (20 S) - Heraeus translux power blue Gebrauchsanweisung

7.2 Selection of "Fast" exposure (10 s – 20 s)
Exposure time 10 seconds:
• Briefl y press the button on the hand piece to start the "Fast" (10 seconds)
• An acoustic signal (1 beep) is sounded upon commencement.
• After 10 seconds an acoustic signal (1 beep) is sounded.
• The "Fast" (10 s) cycle is complete.
Exposure time 20 seconds:
• Within 3 seconds of the end of the previous exposure phase, press the button
• The following acoustic signals are sounded:
GB
- 18 -
7.3

Selection of "Slow rise" exposure (20 s)

Prerequisite: no immediate light exposure has previously taken place.
• Press and hold in button on the hand piece for two seconds to start the
• The following acoustics signals are heard:
At the end of the treatment, place the hand piece of the Translux Power Blue in the loading
tray of the charger (see paragraph 6.1.1 Charger unit).
NOTE!
Interruption of the cycle: the exposure cycle can be interrupted at any time
in both "Fast" and "Slow rise" functions by pressing the button on the hand
piece. If, after a cycle has been interrupted, you wish to start an exposure
of 20 seconds in "Slow rise" mode, you must fi rst wait 3 seconds before
pressing the button again.
NOTE!
Subsequent exposures: at the end of each exposure, new, successive
cycles can be executed by applying appropriate pressure to the button
on the hand piece.
exposure cycle (see paragraph 4.2 Operating and display elements).
on the hand piece for at least 2 seconds.
– 1 beep at the beginning of exposure.
– 1 beep after 2 seconds.
– 1 beep after 10 seconds of exposure time.
– 1 beep at the end of the 20 seconds of exposure time.
"Slow rise" exposure cycle.
– One signal (1 beep) when the button is pressed to start the exposure cycle.
– Another signal (1 beep) 2 seconds after the cycle has started (this confi rms
initialisation of the Slow rise cycle).
– After 10 seconds another acoustic signal (1 beep) is sounded.
– After 20 seconds another acoustic signal is sounded;
the "Slow rise" cycle is complete (1 beep).