Date And Time; Network Settings - Blackmagic Design Hyperdeck Shuttle Hd Installations- Und Bedienungsanleitung

Date and Time

Set your date and time automatically by ticking the box. When setting the date and time
automatically, your HyperDeck Shuttle will use the network time protocol server set in the
NTP field. The default NTP server is time.cloudflare.com, but you can also manually enter
an alternate NTP server and then click on 'set'.
If you are entering your date and time manually, use the fields to enter your date, time and time
zone. Setting the date and time correctly ensures your recordings have the same time and
date information as your network and also prevents conflicts that can occur with some network
storage systems.

Network Settings

Protocol
To control your HyperDeck Shuttle with ATEM switchers, or to control it remotely via HyperDeck
Ethernet Protocol, the HyperDeck Shuttle needs be on the same network as your other
equipment using DHCP or by manually adding a fixed IP address.
HyperDeck Shuttle disk recorders arrive set to DHCP by default. The dynamic host
configuration protocol, or DHCP, is a service on network servers that automatically
finds your HyperDeck disk recorder and assigns an IP address. The DHCP is a
DHCP
great service that makes it easy to connect equipment via Ethernet and ensure
their IP addresses do not conflict with each other. Most computers and network
switchers support DHCP.
When 'static IP' is selected, you can enter your network details manually. When
Static IP setting IP addresses manually so all units can communicate, they must share the
same subnet mask and gateway settings.
Blackmagic HyperDeck Setup 99