Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The engine stop during working
Strange noise
The blade worn or damaged
Belt slipping
Wood logger fails to be separated
effectively
EN
to blow out any oil in the cylinder, then wipe off the
plug and reinsert it.
• if the safety switch is reset and wire is connected?
• if the engine is stopped by overloading?
• if wood is blocked in blade house?
• if the safety switch is in normal condition?
• if the engine with enough fuel and oil?
• Stop the machine, check if any hardware gets loose?
• if not, ask the professionals to check and do
maintenance.
• Go to the professional repair sites to change or sharp
the blades.
• immediately stop the machine, ask professional staff to
open the belt cover, check the wear of the belt, and if
the belt is damaged, replace it with a new one; If the
belt is normal, it is necessary to loosen the engine fixing
bolts, adjust the front and rear positions of the engine
to tension the belt, and then reinstall the belt cover
after completion.
• immediately stop the machine, ask professional staff to
adjust the blade space (open the gear cover, loosen the
bolts pressed onto the cone sleeve of the upper blade
shaft and gear, rotate the upper blade shaft, adjust the
relative position of the gear and blade shaft, select the
appropriate gap between the upper and lower blades,
lock the bolts on the cone sleeve, and then install the
gear cover back)
Werbung
