hillvert HT-WBL-01 Bedienungsanleitung Seite 25

Fix finished upper part of feed hopper 91 and outlet hopper31 on main frame by hardware; Connect wire 102 to
engine control wire., pull out the left pin on the safety switch on safety bar 10. Fix tow bar 93 by knob 94 on the
frame.
F. Battery assembly and connection
Connect the positive and negative wires of battery wire 98 to the positive and negative poles of battery 96, with
the positive pole connected to the positive pole and the negative pole connected to the negative pole. Do not
connect them incorrectly, otherwise it will damage the battery and engine Fix battery cover 97 on battery 96,
and locked them on the frame by bolt 99.
HT-WBL-02
A. Frame assembly
Two eyebolts 88 should be selected as the main lifting points, lift main frame slowly to a height of 40-60 cm
above the ground with a lifting device with a lifting capacity of over 300kg, paying attention to safety! Install T-
bar 4, tow bar 6, axle 7 and wheels (2&3) by D-pin 51, 52, and bolt 69 and hardware.
B. Feed hopper assembly
EN
Part number Part description
100 Lock nut
99 Bolt
98 Battery wire
97 Battery cover
96 Battery
1 Engine