hillvert HT-WBL-01 Bedienungsanleitung Seite 30

• [HT-WBL-02] If the machine is stopped during working and the wood is stuck on the blade and
cannot be cut off, please unscrew the bolt 67 and remove the shaft cover 38. Use a tool wrench C
with a diameter of 30mm to clamp the hexagonal body on the blade shaft 21. Turn the upper blade
shaft 21 counterclockwise to release the blade from the wood. Remove the stuck wood and fix the
shaft cover 38 before restart the machine.
• This machine can cut unsorted or preprocessed branches, so fresh cut branches, plant stems, etc.
can be directly for cutting. Due to factors such as raw material type, moisture content, and
hardness, the machine may experience engine overload, stalling, and body shaking during working
which is a normal situation.
• If it is necessary to cut down hard perennial trees or dry wood, the feed diameter should be
reduced to prevent engine overload and shutdown, and to reduce damage to the engine, blades,
and other components of the vehicle. This machine has the best cutting effect on fresh cork.
• Please ensure that the position below the discharge port is open and there are no other situations
that may affect the discharge before working.
• Feed the material on both sides in front of the feeding hopper, do not operate directly towards the
machine's feeding port. When feeding, do not vigorously hold the wood, just gently push the wood
in; cleaning and collection operations directly below the discharge port are forbidden.
• Due to the processing characteristics of this machine, the user only needs to gently push the wood
into the feeding hopper. After the raw wood is fed into the feeding hopper, it will continue to fully
process the entire section of raw material until the end, without any operation by the user.
However, stopping midway can cause incomplete cutting of the wood and blade jamming.
Therefore, in non-emergency situations, this machine is not allowed to touch the safety bar and is
not allowed to stop midway during work. In addition, short block wood materials should not enter
the feed hopper for cutting, as they will break horizontally in the wooden box during cutting,
causing engine overload and shutdown, and even causing damage to blades or other parts of the
machine.
• [HT-WBL-01] The discharge port is equipped with hooks for collection bags, but collection bags
can only be placed if the following two conditions are met:
a) The placement and replacement of the collection bag are operated by a dedicated person.
After placement, the collection bag should be lower than the lower edge of the discharge
port, making it easy to observe the stacking status of wood inside it. This ensures that the
collection bag can be detected in a timely manner after filling without causing blockage at
the discharge port, and is quickly removed and replaced with a new collection bag in a timely
manner.
b) If single user operates alone and requires a collection bag to collect wood logger, it is necessary
to ensure that the collection bag can completely hold the entire volume of the raw wood,
ensure that the wood does not overflow inside the collection bag, and prevent serious damage
to important components such as the blade and blade shaft due to the blockage of the
discharge port caused by the overflow of wood inside the collection bag.
3.4.
Cleaning and maintenance
a) Engine service interval table (unless otherwise specified by the manufacturer of the engine unit):
Activity / Interval *
Inspection
Engine
possible
oil
supplement
EN
After 1 month
Before or the first 20
each man-hours
use from 1.
commissioning
of
x
Every 3
months or Every year or
every 50 100 working
operating hours
hours