Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Replacement
Control
Air
filter
Cleaning
***
Replacement
Cleaning the fuel drop tank
Control and if necessary,
adjusting the spark plug
gap
Fuel tank - cleaning
Check the sharpness of the
knives/splines
Tire pressure
Clean the outside of the
engine (tarnish, dust, etc.)
Fuel hoses - inspection
Cleaning the inside of the
cylinder head or piston
from carbon build-up ****
** If the machine works frequently under load or in extremely hot ambient
conditions - reduce the interval to 25 working hours.
*** If the machine often works in a dusty, dirty environment, the cleaning interval
should be reduced to 10 working hours, and replacement every 25 working hours.
****The service must be performed by a specialist.
b)
Before each cleaning, adjustment or replacement of accessories, and when the unit is not in use, turn
off the machine and cool it down completely, also remove the ignition cable pipe from the spark plug.
Wait until the rotating parts stop.
•
c)
Use only non-corrosive cleaning agents for cleaning the surfaces.
d)
Store the unit in a dry and cool place protected from moisture and direct sunlight.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the casing.
g)
Clean the ventilation openings with a brush and compressed air.
h)
Perform regular inspections of the unit checking technical fitness and any damages.
i)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) for cleaning as they may
damage the surface of the appliance material.
j)
Check the fuel cables regularly for any damage or wear (cracks or leaks) and replace the damaged
component immediately.
k)
Spark plug inspection/replacement:
ATTENTION: remove the plug only on a cold engine!
Access to the plug is between the air filter housing and the muffler. First, remove the ignition cable pipe
from the spark plug to gain access to it. Before installing a spark plug - including a new spark plug - check
the spark plug gap and adjust it if necessary. When screwing in the plug, do so as far as it will go, but
tighten it sensitively - usually another 1/3-1/2 turns (see the plug manufacturer's recommendations).
The rest of the assembly reverses to disassembly.
EN
x **
x
X
x
x
x
(replacement if necessary)
Every 125 hours of operation
* Depending on what falls sooner.
x
x
(replacement
if necessary)
Every 2 years
x
x
x
Werbung
