hillvert HT-WBL-01 Bedienungsanleitung Seite 34

• If necessary, inflate the air in the wheels to the maximum allowable pressure (see the marking
on the tire).
• Store the machine in a dry, roofed building with good ventilation and away from heat and
sunlight.
o) Please inspect the machine parts under the guidance of professionals or professionals regularly
with 1-2 times monthly. Ensure the machine completely stopped!
• [HT-WBL-01] Open the gear cover 36, belt cover 13, gear small cover 43 and discharge port 31,
give an appropriate amount of lubricating grease to each gear component; Check for flexible
rotation and wear of key parts such as bearings, blades, belts, etc. If defects are found, they
should be promptly repaired before rework. Especially for blades, regular inspections are
required and blade repairs are carried out at professional institutions. A blunt blade can reduce
the efficiency of the machine, and in severe cases, it can cause damage to machine
components.
• [HT-WBL-02] open the gear cover 36 by removing the 4x holding it b77 bolts. Grease each gear
component; Check for flexible rotation and wear of key parts such as bearings, blades, belts,
etc. If defects are found, they should be promptly repaired before rework. Especially for blades,
regular inspections are required and blade repairs are carried out at professional institutions.
A blunt blade can reduce the efficiency of the machine, and in severe cases, it can cause damage
to machine components.
SAFE REMOVAL OF BATTERIES
GEL 12V 9Ah batteries are installed in the devices.
Remove used battery from the device using the same procedure by which you installed them.
Recycle batteries with the appropriate organisation or company.
DISPOSING OF USED DEVICES
Do not dispose of this device in municipal waste systems. Hand it over to an electric and electrical device
recycling and collection point. Check the symbol on the product, instruction manual and packaging. The
plastics used to construct the device can be recycled in accordance with their markings. By choosing to recycle
you are making a significant contribution to the protection of our environment.
Contact local authorities for information on your local recycling facility.
TROUBLESHOOTING
Problem
The engine cannot be started
EN
Possible cause
• Is the ignition switch in the "ON" position?
• Is the fuel shut-off valve on?
• Are you using fresh, clean gas? If the gas is old, change
it.
• Use a fuel stabilizer if you keep gas longer than 30 days.
• Is the spark plug clean? If the spark plug is dirty or
cracked, change it. If it's oily, leave it out, hold a rag
over the plug hole and pull the recoil cord several times