Jungheinrich DFG 316s Betriebsanleitung Seite 2

Foreword
Safe operation of the industrial truck requires specialist knowledge, which is acquired
from this Operating Manual, from the training required by OSHA under 29 CFR
1910.178, and by training operators in factory installations and their functions. Safe
operation of the industrial truck requires knowledge that can be acquired from this
ORIGINAL OPERATING MANUAL. The information is set out concisely and in a clear
format. The chapters are organized alphabetically, each starting at page 1. The page
identifier consists of the chapter letter and page number.
For example: Page B2 is the second page of Chapter B.
Various types of industrial trucks are described in this Operating Manual. When
operating the truck and carrying out maintenance work, make certain you use the
description corresponding to your vehicle type.
Safety instructions and important information, and their relative importance, are
indicated by the following safety warning symbols and indicator words:
QwD
This message indicates a hazardous situation that, if not avoided, will result
in death or serious injury. The instructions, safety precautions, actions, or
procedures relating to this message must be observed to avoid the risk of
death or serious injury.
Qw W
This message indicates a hazardous situation that, if not avoided, could
result in death or serious injury. The instructions, safety precautions, actions,
or procedures relating to this message must be observed to avoid the
potential risk of death or serious injury.
QwK
This message indicates a situation that may lead to minor or moderate injury
if disregarded. The instructions, safety precautions, actions, or procedures
relating to this message must be observed to avoid the risk of minor or
moderate injury.
IMPORTANT This message appears if special precautionary measures are needed to
ensure that the correct action is taken or to prevent damage to or malfunction
of the industrial truck or a component.
NOTICE This message appears if special information, instructions, or indications are
needed with regard to procedures, equipment, tools, pressures, loads, and
other special data.
t
Indicates component fitted as standard.
o
Indicates optional extra.