Engine Maintenance Dfg 425S-430S - Jungheinrich DFG 316s Betriebsanleitung

12.5

Engine maintenance DFG 425s-430s

Replacing engine oil and filter
IMPORTANT Starting 11/06, the DFG4s use
a Perkins 404C-22T engine.
See DFG 316s/320s for engine
maintenance, V-belt tension
and fuel system.
IMPORTANT Only replace engine oil when it
is at operating temperature
and when the vehicle is in a
horizontal
replace the engine oil and filter
together.
Drain engine oil
– Unscrew cap (36).
– Clean oil drain plug (37) and around the drain hole thoroughly.
– Unscrew oil drain plug and drain oil
into a suitable container.
Qw W
Caution: risk of scalding from
the hot oil.
– Screw oil drain plug on again with a
new seal.
IMPORTANT Properly dispose of used oil.
Replacing engine oil filter
– Loosen oil filter (38) with a filter
wrench and unscrew by hand.
IMPORTANT Collect draining oil; properly
dispose of oil filter and oil.
– Clean seal surfaces and oil filter
flange thoroughly.
– Lightly oil new filter seal with fresh
engine oil.
– Screw on oil filter by hand.
position. Always
G 31