Jungheinrich DFG 316s Betriebsanleitung Seite 155

Fill engine oil
– Fill fresh engine oil into the opening
according
resources table (see Section 8).
Fill quantity: 6.9l
– Check oil level with dipstick (59),
correct if necessary (see Chapter 8,
Section 2).
– Screw cap back on.
– Reinsert dipstick completely.
IMPORTANT After oil and oil filter have been
replaced, check oil pressure
warning light (60) during an
engine test run, and check the
oil drain plug and oil filter for
leaks.
Check V-belt tension
– Push in s-toothed v-belt between the
radiator V-belt pulley (61) and the
alternator V-belt pulley (62) with a
force of 10 lbf / 45 N.
The V-belt should push in approx. / 10
mm.
Setting the V-belt tension
– Loosen screws
alternator (64) in direction of arrow
until the
reached.
– Retighten screw.
– Recheck V-belt tension and repeat
setting procedure if necessary.
G 38
(56) to operating
(63) and
specified tension
pull
is