Jungheinrich DFG 316s Betriebsanleitung Seite 15

– Overload the industrial truck or use it if the arrangement of the load does not
match that shown in the load diagram
(see "Load diagram" in Chapter D)
– Use the industrial truck as a crane
– Lift or carry people
– Lock a control in position
– Ignore conventional practice in connection with the handling of loads
– Carry loads over people's heads
– Push or pull loads (except for trailers)
– Take part in games, such as races
– Carry loads that are not fully balanced
3. The owner and operator must check the load-bearing capacity of floors (to
prevent damage), shelves, and, in general, all gangways in which the industrial
truck may possibly be used.
4. Read the instructions on the signs attached to the industrial truck and ensure
that they are always legible.
5. This Operating Manual must be made available to all operators.
6. Ensure that only trained, tested, and responsible people who are capable of
operating the vehicle safely are allowed to operate the industrial truck.
7. Ensure that the industrial truck cannot be moved when it is not in use.
8. An industrial truck that is clearly not in good working order must not be used.
9. The industrial truck must never be used to transport a load or to apply a force if
the maximum permissible operating load would be exceeded as a consequence.
10. The industrial truck must only be used in the manner for which the truck was
designed.
11. Read the safety instructions applicable for this industrial truck and comply with
these instructions without exception.
12. The manufacturer accepts no liability for consequences arising from the
dismantling of the industrial truck or from modifications outside the
manufacturer's control.
13. The manufacturer's liability is limited to the configuration of the machine
described in the Declaration of Conformity. The manufacturer is absolved from
all liability if modifications or additions are made or equipment from another
supplier is used. In such a case the manufacturer's liability is transferred to the
user.
14. This Operating Manual shall cease to be valid if the machine is modified by a
company outside our Group, even if original spare parts are used and our
company logo still appears on the machine.
15. Exceptional operating conditions require additional safety precautions and
special operating instructions.
16. Supervision is essential to the safe use of powered industrial trucks.
17. Wheel chocks and wheel locks (where fitted) are only suitable for holding the
industrial truck in the required position on a level surface.
C 4