Jungheinrich DFG 316s Betriebsanleitung Seite 152

– Screw on oil filter by hand.
Fill engine oil
– Fill fresh engine oil into the opening
according to operating resources
table (see Section 8).
Fill quantity: 4.7l
– Check oil level with dipstick (51),
correct if necessary (see Chapter 8,
Section 2).
– Screw cap back on.
– Reinsert dipstick completely.
IMPORTANT After oil and oil filter have been
replaced, check oil pressure
warning light (52) during an
engine test run, and check the
oil drain plug and oil filter for
leaks.
Replacing the spark plugs
– Remove spark plug connector (53) .
– Clean area around spark plugs on
the cylinder head thoroughly.
– Unscrew spark plugs.
– Check electrode gap on the new
spark plugs, adjust if necessary.
Set point: 0.06 inch (1.5 mm)
IMPORTANT Use only original spark plugs.
– Screw in the spark plugs by hand
and then tighten with a torque of
14.75 lbf ft / 20 Nm.
G 35