Jungheinrich DFG 316s Betriebsanleitung Seite 160

Method
This method is recommended if the
forklift is
compartments.
points are as follows:
– Jacking point (1) is under the fender
as close to the chassis side plate as
possible.
– Jacking point (2) is under the
steering axle on the forklift's center
line.
Qw W
See Chapter H, Section 1!
– Unscrew wheel nuts.
– Remove wheel.
– Mount new wheel.
– Screw on wheel nuts by hand.
– Beginning with A, tighten wheel nuts
with reduced torque in the order
shown in the illustration.
– Tighten wheel nuts in the same
order with the specified torque.
Torque
Drive wheels (316s/320s)
ft / 210 Nm
Drive wheels (425s-430s)
Drive wheels (540s-550s)
Rear wheels (316s-430s)
Rear wheels (540s-550s)
equipped with lower
The jack position
155 lbf
339lbf ft / 460 Nm
383.5 - 457 lbf ft / 520-620 Nm
130 lf ft / 176 Nm
368.7 - 383.5 lbf ft / 500-520 Nm
G 43