Checking And Adjusting The Centre Of Gravity - Reely Mini Hawk Bedienungsanleitung

i) Checking and adjusting the centre of gravity
After the flight battery is installed, make sure you check
the centre of gravity. To do this, put on the canopy.
The centre of gravity is 42 mm behind the leading edge. If
the model is supported at this point, it must be balanced
horizontally.
The model structure enables precise adjustment of the
centre of gravity by moving the flight battery.
If the battery cannot be moved any further, you can also
use commercially available small rim weights to adjust the
centre of gravity, if necessary.
Our tip from experience:
Attach two narrow strips of insulating tape to
the bottom of the wing on the right and left in
the area of the centre of gravity (see Figure 14,
no. 1).
By lifting the model right and left with your finger and balancing it, you will immediately find out whether the
actual centre of gravity is in the area of the adhesive strip.
Figure 14
61