HP CM8060 Color MFP Kundendienst Handbuch Seite 152

General procedures
●
General cleaning
●
Cleaning spilled ink
●
How to clean an ink or Bonding Agent spill on carpet
●
Cleaning the control panel
●
Resetting preventive maintenance counters
● Cleaning pick rollers
General cleaning
VORSICHT!
begin these steps.
ACHTUNG:
careful not to touch the transfer or delivery rollers. Skin oils on the rollers can cause print-quality
problems.
●
Vacuum the inside of the MFP regularly (approximately every 120K pages), primarily for the paper
dust and other debris that is generated. The dust can build up on the IDO sensors, output door,
the finisher, and on the floor around the unit.
●
If the outside of the MFP and its accessories are visibly marked, clean them with a water-dampened
cloth.
●
Clean the inside of the MFP and its accessories with a dry, lint-free cloth.
●
Ample wipes are provided with applicable field replaceable units (FRUs). Use as needed to clean
internal ink-soiled areas, and then return soiled wipes with the FRU for disposition. Escalate for
support in the unlikely event that spillage can not be readily absorbed in wipes provided.
HINWEIS:
parts and consumables" auf Seite
Cleaning spilled ink
Follow these instructions to remove ink from your skin and clothing:
ACHTUNG:
Surface
Skin
White fabric
Color fabric
ACHTUNG:
the fabric.
86 Kapitel 4 Managing and maintenance
In order to avoid shock hazard, turn the printer off and unplug all power cords before you
Do not use ammonia-based cleaners on the MFP and its accessories. While cleaning, be
Dispose of all wet material as appropriate. See
Use gloves and safety glasses when handling ink parts.
Remedy
Wash the area with an abrasive soap.
Wash the fabric in cold water and use chlorine bleach.
Wash the fabric in cold water and use sudsy ammonia.
Always use cold water to remove ink from fabric. Warm or hot water can set the ink into
26.
„Handling and disposing of service
DEWW