HP CM8060 Color MFP Kundendienst Handbuch Seite 119

To perform the scan and analyze function using CDFT-L:
1. Click Settings/Procedures, and then click Scan and Analyze. Follow the instruction on the
screen.
2. Select one test from the list by clicking on it to enable the options buttons at the bottom of the
screen. You have these three options:
●
Load existing image: Select this option if you have a previously stored tiff file that you want
to analyze again.
● Target already printed: Select this option if you already have a printed target for the selected
test. Follow the instructions to place the printed target on the platen glass to run the test.
●
Print Target: Select this option to run a test from scratch, when you click on this button the
target for the selected test will be printed. Follow the on screen instruction to load the printed
target on the platen glass to run the test.
3. Place the printed target face down on the scanner glass, look a the picture on the screen to orient
the target in the correct direction, make sure the target is properly registered on the rear left corner
close the ADF and then click Scan.
4. The target will be scanned and the scan raw data will be stored in tiff format in the coprocessor
HDD. A tiff file named "rawdata.tif" of the scanned target will be copied to the following directory in
the laptop "C:\CDFTScanData\". CDFT-L will perform the analysis on the copied file.
Every time a test is performed the existing "rawdata.tif" file will be replaced by the new scanned
image, unless the user saves the image with a different name from the results test. Refer to Scan
and analyze test results presentation.
Depending on the network connection type selected to run CDFT-L, the test can take from 4 to 6 minutes.
Once the test is done, the results will be displayed in a tabular format. The table headings and the
number of columns will depend on the selected test.
Additionally, the results screen will give the user the option to save the scanned TIFF image and test
results under a different name. By default, the name of the saved image is as
follows: "TestName_rawdata_dd_m_yyyy_h_mm_am.tif"
i.e. "VerticalBanding_rawdata_12_2_2006_2_17 PM.tif".
In case the fiducials or reference points in the target can't be found, an error message will appear
describing the cause of the error, the potential root causes, and the recommended actions. Follow the
recommended actions and then repeat the test.
Use service assist mode
● Understand service assist mode
● Start service assist mode
● End service assist mode
Understand service assist mode
Service assist mode allows customers to access a subset of CDFT-E features. Typically, an end user
uses this restricted mode to access the application's features when receiving phone support.
DEWW Troubleshoot the MFP and accessories 53