HP CM8060 Color MFP Kundendienst Handbuch Seite 160

IDO media eject fingers, output sensors, and linkage bushings
Reattach the finisher.
Clean media eject fingers (6 minutes)
1. Enter CDFT.
2. Pull the finisher away from the engine.
3. Open the left-side upper panel.
4. Insert an interlock cheater key into the left-side upper panel door sensor (door lock override).
5. In CDFT, select Subsystems, select Paper Path, and then select IDO Motors.
6. Press the M13 Media Eject button with the arrow pointing diagonally down.
7. Observe the media eject fingers moving down to expose their tips.
8. Use lint free cloth and distilled water to gently clean the tips of the fingers.
9. When the fingers are clean, press the M13 Media Eject button with the arrow pointing diagonally
down.
10. Observe the media eject fingers moving back to their normal position.
11. Remove the interlock cheater key and close the left-side upper panel.
12. Use lint free cloth and distilled water to gently clean the tips of the fingers.
13. Exit CDFT.
Clean IDO Output 1 sensor (SN15) and IDO Output 2 sensor (SN12) (1 minute)
▲ Use a vacuum cleaner or a blast of compressed air to clean paper dust from IDO Output 1 sensor
(SN15) (callout 1) and IDO Output 2 sensor (SN12) (callout 2).
94 Kapitel 4 Managing and maintenance DEWW