HP CM8060 Color MFP Kundendienst Handbuch Seite 133

e. Increase the current value if the distance measured is less than the specification.
f. Touch Enter to update the setting.
11. Confirm adjustment
a. Place the printed target page face up in the ADF input tray with the top edge of the page
facing left.
b. Touch Double-Sided to make another two-sided copy and confirm the adjustment.
12. Centerline Duplex Back adjustment
a. Place the printed target page face down in the ADF input tray with the top edge of the page
facing left.
b. Touch Double-Sided.
c. Measure the distance from the left edge of the paper to point E in the copy. If the measured
value is within the specification listed above, stop here.
d. Touch the + or - Centerline Duplex Back buttons to adjust.
e. Decrease the current value if the distance measured is less than the specification.
f. Touch Enter to update the setting.
13. Confirm adjustment
a. Place the printed target page face down in the ADF input tray with the top edge of the page
facing left.
b. Touch Double-Sided to make another two-sided copy and confirm the adjustment.
Tray calibrations
To access the Tray calibration screen, click Settings/Procedures, click Calibrations, and then click
Tray Calibrations.
●
To calibrate the Tray 1 width slider, select one of the three calibration positions displayed.
●
Use a ruler to accurately position the width slider to the selected position.
●
Press the Calibrate button.
●
Repeat for all three positions.
DEWW Calibrate the MFP 67