Performance settings
The MFP uses a series of pinch rollers to transport printed and dried sheets from the drum. In some
cases, the pinch rollers can transfer ink to either the same page or on successive pages resulting in
poor print quality. The MFP uses a firmware algorithm to impose additional dryer passes on problematic
pages to protect against roller ink transfer, resulting in a slower system print speed. You can enable or
disable this algorithm in CDFT (firmware release version 20071204 73.022.0 and newer).
The algorithm is enabled by default and should only be disabled for troubleshooting purposes. If the
algorithm is disabled, no extra dryer passes will be added and the device will be susceptible to roller ink
transfer.
HINWEIS:
reasons, but that is not generally recommended.
The Roller Ink Transfer prevention algorithm is enabled or disabled completely from the Performance
Settings screen in CDFT. Use this screen to view the current status of the algorithm.
1.
Touch Settings/Procedures on the CDFT screen.
2.
Touch Performance Settings.
3.
Select whether or not extra drying is activated.
4.
Touch Save Changes.
5.
Exit CDFT.
76
Kapitel 3 Copier Diagnostic Field Tool (CDFT)
In some unique cases, a customer might want this functionality disabled for performance
DEWW