HP CM8060 Color MFP Kundendienst Handbuch Seite 132

c. Increase the current value if the distance measured is less than 127 mm (5.0 in).
d. Touch Enter to update the setting.
e. Place the printed target page face up in the ADF input tray with the top edge of the page facing
left.
f. Touch Copy Target Page to make another copy and confirm the Vertical Magnification
adjustment.
7. Leading Edge adjustment
a. Measure the distance from the top edge of the paper to point F. If the measured value is 20
mm ± 2 mm (0.79 in ± 0.08 in), skip to the Single-sided Centerline adjustment.
b. Touch the + or - Leading Edge buttons to adjust.
c. Decrease the current value if the distance measured is less than 20 mm.
d. Touch Enter to update the setting.
8. Centerline Simplex adjustment
a. Measure the distance from the left edge of the paper to point E. If the measured value is within
the following specification, skip to Confirm adjustments.
Target page size
Dimensional Image Quality 11x17
Dimensional Image Quality A3
Dimensional Image Quality 8.5x11
Dimensional Image Quality A4
b. Touch the + or - Centerline Simplex buttons to adjust.
c. Increase the current value if the distance measured is less than the specification.
d. Touch Enter to update the setting.
9. Confirm adjustments
a. Place the printed target page face up in the ADF input tray with the top edge of the page
facing left.
b. Touch Single-Sided and confirm all adjustments.
10. Centerline Duplex Front adjustment
a. Place the printed target page face up in the ADF input tray with the top edge of the page
facing left.
b. Touch Double-Sided.
c. Measure the distance from the left edge of the paper to point E in the copy. If the measured
value is within the specification listed above, skip to Centerline Duplex Back adjustment.
d. Touch the + or - Centerline Duplex Front buttons to adjust.
66 Kapitel 3 Copier Diagnostic Field Tool (CDFT)
ADF centerline specification (Simplex or Duplex)
139.7 mm ± 2 mm (5.5 in ± 0.08 in)
148.5 mm ± 2 mm (5.85 in ± 0.08 in)
107.9 mm ± 2 mm (4.32 in ± 0.08 in)
105 mm ± 2 mm (4.13 in ± 0.08 in)
DEWW