HP CM8060 Color MFP Kundendienst Handbuch Seite 123

Use a USB flash drive to upgrade the firmware
HINWEIS:
mode and Service Assist mode. Updates with a USB flash drive through the Startup Menu are not
supported.
1. Insert the USB flash drive containing the upgrade files into the host USB connector on the lower
left side of the MFP.
2. Click Settings/Procedures, and then click Firmware Upgrade.
CDFT detects the drive and displays a list of the available upgrade files on the USB drive. (The .RFU
upgrade file is considered valid if it contains a valid header.) Upgrade information is displayed about
the MFP's current firmware version and the upgrade version.
3. Click Upgrade to initiate the firmware upgrade.
HINWEIS:
OK to proceed with the upgrade. For specifics about data loss within a release, refer to the release
notes for that firmware version.
4. After the upgrade file from the USB drive has loaded, the MFP will automatically reboot.
5. Remove the USB drive.
DEWW
Firmware updates using a USB flash drive can only be done through CDFT-E in Ready
If CDFT determines that data loss is possible, a warning message is displayed. Click
Manage and maintain firmware 57