HP CM8060 Color MFP Kundendienst Handbuch Seite 168

●
Administrator startup options
Installation options
Use the options available from the Installation Options menu to override the default behavior of the
RFU installers.
Follow these steps to set the installation options:
1. Enter the Startup Menu. For help, see
2. Select Administrator Tools.
If the administrator tools are password protected, sign in to the Startup Menu.
3. Select Installation Options.
4. Select the options that you want:
Option
Force All
Disable All
Reset to Defaults
Reformat Coprocessor Drive
Subsystem Install Options
Firmware Download
To perform an RFU over USB, use the Firmware Download menu to prepare the MFP to receive the
RFU file. Before starting a RFU, you can use the Installation Options menu to override specific RFU
settings. For more information, see
HINWEIS:
2.0-compliant cable results in degraded performance.
102 Kapitel 4 Managing and maintenance
Use a USB 2.0-compliant cable and laptop to upgrade the firmware. The use of a non-USB
„How to use the Startup Menu" auf Seite
Function
Sets each of the subsystems listed under Subsystem Install Options to Force.
When selected, this option takes effect when the power cycle continues and affects
only this power up.
Sets each of the subsystems listed under Subsystem Install Options to
Disable. When selected, this option applies to all subsequent power cycles.
ACHTUNG: Using this option can lead to firmware incompatibility errors.
Sets each of the subsystems listed under Subsystem Install Options to
Automatic.
Deletes the entire contents and rewrites the partitioning information for the
Coprocessor drive. The subsystem firmware that resides on the drive is reinstalled
at the next power cycle.
ACHTUNG: All user data on the Coprocessor drive is lost.
For each subsystem listed, you can set the following options:
●
Automatic: The firmware for the subsystem is installed only if the subsystem
firmware in the RFU file is of a different version than the firmware already
installed.
●
Force: Reinstalls the firmware for the subsystem even if the currently
installed subsystem firmware is the current version. When selected, this
option applies only to the next power cycle.
●
Disable: Disables the installation of the firmware for the subsystem even if
the currently installed subsystem firmware is not the correct version.
ACHTUNG: Using this option can lead to firmware incompatibility errors.
„Installation options" auf Seite
101.
102.
DEWW