HP CM8060 Color MFP Kundendienst Handbuch Seite 227

Pick force
HINWEIS:
1. Remove the left bottom panel.
„Linke untere Klappe" auf Seite 731
2. Open the Tray 5 top door, and then tape down the arm lifter link (callout 1) and the Tray 5 Media
Door Open sensor (SN107) (callout 2), letting the elevator tray rise to its highest position.
3. Loosen two screws below the pick force adjustment wingnut.
4. Turn the wingnut counterclockwise until the pick arm drops, then clockwise just until the arm barely
rises off the elevator tray.
DEWW
Calibrating the stack height is a prerequisite to setting the pick force.
Tray 5 calibrations 161