HP CM8060 Color MFP Kundendienst Handbuch Seite 99

Safety notes
To reduce risk of injury from fire or electric shock, always follow basic safety precautions when using
the device.
Observe all warnings and instructions marked on the device.
Do not touch the contacts on the end of any of the sockets on the device. Replace damaged cords
immediately.
Do not install or use the device near water or when you are wet.
Use only a grounded electrical outlet when connecting the device to a power source.
There is a risk of explosion if the battery is replaced with an incorrect type. Dispose of used batteries
according to the instructions.
Be careful of sharp edges at various locations on the MFP.
Warning!: Risk of injury from moving parts. Do not reach into stapler. Do not reach below moving
trays.
Do not install a door interlock override device on the lower-left door interlock before you remove and
replace an ink cartridge.
To prevent personal injury, do not install a door interlock override device while clearing a media jam.
The system will start automatically once the jam is cleared and all of the MFP interlocks are closed.
Once the last MFP door is closed or an interlock override device is installed, there might be some delay
before the system resumes printing.
To prevent personal injury, use caution when installing a door interlock override device. Once the last
MFP door is closed or a door interlock override device is inserted, and without any jams present, there
is a few seconds' delay before the carriages move, potentially causing pinch points.
To activate and deactivate the IDS relief valve with the IDS pressurized, the system must be in PSM
mode. If service wants to activate and deactivate the IDS relief valve while the IDS is pressurized in a
non-CDFT PSM mode, the IDS air system cannot be pressurized.
Ensure that the Network and Fax cables are physically removed from the MFP before entering CDFT.
This will prevent print and fax jobs from starting unexpectedly during MFP servicing.
There are certain pen servicing routines that will be initiated occasionally at the end of a print/copy job.
There is a 2-second delay from the end of the print/copy job to the start of the pen servicing routines.
Use gloves and safety glasses when handling ink parts.
Multifunction finishers and 4-bin separators have sharp metal edges near their wheels which can pose
a safety risk to anyone who sticks their hand underneath the device. In order to reduce this risk, all
devices should have a protective cover over these edges.
DEWW Safety notes 33