HP CM8060 Color MFP Kundendienst Handbuch Seite 222

2. Hold down the media release button (callout 3) while slipping two sheets of fresh standard-weight
paper under the pick arm. Position the trailing edge of the sheets slightly past the paper-width guide
opening in the elevator tray.
HINWEIS:
3. In CDFT, select M101 Pick to run the pick motor. If the correct amount of separator force is being
applied, only the bottom sheet should kickback.
Initialization check
▲ Open, and then close the Tray 5 top door. This runs an initialization test. You can hear the Tray 5
motors running for a few seconds while the test runs. The elevator motor has a distinctive sound.
Once it stops, you should hear the pick motor turn on. This is when the pick/separator testing
occurs. The test runs only once if the separator force was found to be within the correct limits. The
test runs three times consecutively if the separator force is not correct and warning codes are
logged.
If Tray 5 passes the first test, the MFP is within tolerance for pick and separation forces.
If Tray 5 passes the second test, the MFP is marginal and you should follow the steps outlined in
Repair strategy.
You can only determine whether the third test passed or failed by viewing any warning logs in CDFT
related to the third test. If a third test runs, even if Tray 5 passes the test, the MFP is unhealthy.
Follow the steps outlined in Repair strategy.
Any mechanical link between the Tray 5 Pick motor (M101) and the lower separator encoder disk
can cause this test to fail.
Repair strategy
a. Check the pick and the upper and lower separator tires for correct seating. Unsnap the tires
and reposition them to ensure that the tires are seated correctly.
b. Examine the pick and the upper and lower separator tires for wear or contamination, and then
replace if required.
156 Kapitel 5 Calibrations and adjustments
Ensure the paper edges are aligned.
DEWW