HP CM8060 Color MFP Kundendienst Handbuch Seite 129

d. Touch Enter to update the setting.
e. Touch Copy Target Page to make another copy and confirm the Vertical Magnification
adjustment.
7. Leading Edge adjustment
a. Measure the distance from the top edge of the paper to point F. If the measured value is 20
mm ± 1 mm (0.79 in ± 0.04 in), skip to the Centerline adjustment.
b. Touch the + or - Leading Edge buttons to adjust.
c. Decrease the current value if the distance measured is less than 20 mm (0.79 in).
d. Touch Enter to update the setting.
8. Centerline adjustment
a. Measure the distance from the left edge of the paper to point E. If the measured value is within
the following specification, skip to Confirm adjustments.
Target page size
Dimensional Image Quality 11x17
Dimensional Image Quality A3
Dimensional Image Quality 8.5x11
Dimensional Image Quality A4
b. Touch the + or - Centerline buttons to adjust.
c. Decrease the current value if the distance measured is less than the specification.
d. Touch Enter to update the setting.
9. Confirm adjustments
▲ Touch Copy Target Page and confirm all adjustments.
For a full description of the calibration, see
ADF image adjustments
Follow these steps to perform an automatic ADF image adjustment:
1. Click ADF Adjustments on the Calibrations page.
HINWEIS:
Adjustments for this step.
2. Select a paper size of 11x17 or A3, as available in the paper trays. (If these sizes are not available,
use 8.5x11 or A4.)
3. Touch Print Target Page.
4. Place the printed target page face up in the ADF input tray with the top edge of the page facing
left.
5. Touch Single-Sided.
DEWW
Depending on the firmware version, you might need to touch Automatic ADF
Centerline specification
139.7 mm ± 1 mm (5.5 in ± 0.04 in)
148.5 mm ± 1 mm (5.85 in ± 0.04 in)
107.9 mm ± 1 mm (4.32 in ± 0.04 in)
105 mm ± 1 mm (4.13 in ± 0.04 in)
„Scanner adjustments" auf Seite 138
Calibrate the MFP 63