HP CM8060 Color MFP Kundendienst Handbuch Seite 131

c. Measure the distance from the left edge of the paper to point E in the copy. If the measured
value is within the specification listed above, skip to Centerline Duplex Back adjustment.
d. Touch the Centerline Duplex Front adjustment field to select it.
e. Using the keypad, enter the measured value.
f. Touch Enter to update the setting. (Entering a 0 (zero) value does not change a setting.)
11. Confirm adjustment
a. Place the printed target page face up in the ADF input tray with the top edge of the page
facing left.
b. Touch Double-Sided to make another two-sided copy and confirm the adjustment.
12. Centerline Duplex Back
a. Place the printed target page face down in the ADF input tray with the top edge of the page
facing left.
b. Touch Double-Sided.
c. Measure the distance from the left edge of the paper to point E in the copy. If the measured
value is within the specification listed above, stop here.
d. Touch the Centerline Duplex Back adjustment field to select it.
e. Using the keypad, enter the measured value.
f. Touch Enter to update the setting. (Entering a 0 (zero) value does not change a setting.)
13. Confirm adjustment
a. Place the printed target page face down in the ADF input tray with the top edge of the page
facing left.
b. Touch Double-Sided to make another two-sided copy and confirm the adjustment.
Manual ADF image adjustments
Follow these steps to perform a manual ADF image adjustment:
1. Click ADF Adjustments on the Calibrations page.
2. Touch Direct Adjust.
3. Touch Print Target Page.
4. Place the printed target page face up in the ADF input tray with the top edge of the page facing
left.
5. Touch Single-Sided.
6. Vertical Magnification adjustment
a. Measure the copied page from point A to D. If the measured value is 127 mm ± 1 mm (5.0 in
± 0.04 in), skip to the Leading Edge adjustment.
b. Touch the + or - Vertical Magnification buttons to adjust.
DEWW Calibrate the MFP 65