HP CM8060 Color MFP Kundendienst Handbuch Seite 223

c. Run the cleaning routine for the clutches, outlined in Service Advisory c01386766.
d. If the error log reports several A2.04A1 failures and the cleaning procedure outlined in Service
Advisory c01386766 does not prevent these failures, replace the separator clutch.
Separator force adjustment
1. Remove the following covers:
● Pin alignment plate
„Stiftausrichtungsplatte" auf Seite 731
●
Left bottom panel
„Linke untere Klappe" auf Seite 731
2. Loosen two screws.
3. Using a T10 driver, reach underneath and turn the jack screw to adjust tension on the separator
spring, retighten the two screws (right screw first, followed by the left screw), and then run the
initialization test by opening and closing the Tray 5 top door. Repeat until the initialization test runs
only once.
DEWW Tray 5 calibrations 157