HP CM8060 Color MFP Kundendienst Handbuch Seite 224

Stack height
HINWEIS:
1. Open the Tray 5 top door, and then tape down the Tray 5 Media Door Open sensor (SN107) (callout
1).
2. Hold down the arm lifter link (callout 2), wait for the elevator tray to rise to its highest position, and
then release the arm lifter link.
3. Lay a straight edge, such as a ruler, flat on the elevator tray on the right side of the cork pad. Check
to see if the edge of the ruler is at exactly the same height as, or just slightly below, the ridge of
the black guide. If the ruler is not at the same height as, or just slightly below, the ridge, an
adjustment to the Tray 5 Stack Height sensor (SN104) is necessary.
158 Kapitel 5 Calibrations and adjustments
Perform the stack height calibration before adjusting the pick force.
DEWW