HP CM8060 Color MFP Kundendienst Handbuch Seite 198

HINWEIS:
and firmware upgrades.
HINWEIS:
the customer to be successful and to prevent unnecessary service calls.
The MFP will allow stapling in landscape legal mode by following these directions:
HINWEIS:
user selects Top Left. This is the only option possible.
●
Load the legal landscape job into the ADF.
●
Touch Copy on the control panel.
●
Touch Staple.
●
Touch Orientation, and then touch Landscape.
●
Touch Staple, and then touch Top Left.
●
Select the number of copies, and then touch Start.
●
The job prints in landscape mode on legal paper with a staple in the top-right corner. (This is
the only option possible.)
●
Ensure that the page settings in your user program (for example, Microsoft Word) are set to
legal size and landscape mode.
●
In the Properties menu of the print driver, select Legal as the paper size and Top Left for
the output staple option.
HINWEIS:
●
Click OK to exit the Properties dialog box and print the job.
●
The job prints in landscape mode on legal paper with a staple in the top-right corner. (This is
the only option possible.)
Batch printing
By default, the accumulator drops each pring job individually into bin 5 with a 20 mm offset. Use the
following procedure to enable batch printing so that a continuous series of small jobs (not stapled) will
be delivered as a single stack into bin 5, with no job offsetting. This improves output speed for small
jobs going to bin 5, but does not provide any job offsetting. Enable batch stack only at the customer's
request.
1. Install firmware version 74.017.0 or greater.
2. In CDFT, touch Settings/Procedures, and then touch Finisher Settings.
Follow these steps to enable batch printing (batch stack) in bin 5:
●
In the Bin 5 Batch Stack box, touch On.
●
Verify that the Bin 5 Batch Stack box now reads Enabled
132 Kapitel 4 Managing and maintenance
These settings will remain active through reboots, power cycles, firmware reflashes,
This new functionality requires special user actions which might not be obvious. Train
The staple appears in the top right corner of the landscape print job, even though the
Be sure to leave the orientation setting at Portrait.
DEWW