HP CM8060 Color MFP Kundendienst Handbuch Seite 226

6. Slightly loosen the adjustment screw to SN104.
HINWEIS:
ACHTUNG:
HINWEIS:
the sensor. Be sure to test the alignment of the pick arm actuator to the sensor so that the pick arm
actuates the sensor.
7. By prying with a small, flat-bladed screwdriver, raise or lower the gauge to raise or lower the elevator
tray accordingly.
8. Retighten the adjustment screw while holding the gauge/sensor assembly to prevent the assembly
from shifting.
9. Repeat the procedure until the elevator tray stops at the correct height in step 3.
10. Reinstall the paper-width guide.
160 Kapitel 5 Calibrations and adjustments
For easier access to SN104 adjustment hardware, remove the paper width guide.
There are sharp edges on the paper width guide.
Ensure SN104 is straight up and down and not twisted after adjusting and securing
DEWW