HP CM8060 Color MFP Kundendienst Handbuch Seite 164

HINWEIS:
enabled for that device, the device will show as "offline" from the driver and no print jobs can be sent to
it. As a workaround, disable SNMP Status Enabled.
In the Printers and Faxes folder, go to File, then Server Properties, click the Ports tab, select the port
that was set up for that device, and then click Configure. Uncheck "SNMP Status Enabled", and then
click OK.
Drum encoder
Clean the drum encoder disk and the three drum encoder sensors at the same time the drum spittoon
is replaced.
Clean the drum encoder as follows:
ACHTUNG:
a dry, lint-free cloth.
1. Remove two screws, and then carefully lift off the encoder cover.
2. With a flashlight, carefully inspect the encoder disk, encoder cover, and the three encoders for
scratches, debris, such as paper fibers, white powder, black fragments or any other loose material.
Replace the encoder disk if badly scratched in the encoder or index areas.
HINWEIS:
HINWEIS:
and make sure that the two encoder locating pins are fully inserted into the PCA mounting holes.
Also be sure that the encoder cover locating pin is inserted into the PCA mounting hole when
tightening the screw.
3. Wipe the encoder disk with a dry, lint-free cloth.
4. Use a dry lint-free cloth or soft bristle brush to clean each of the three encoder sensors.
5. Replace the encoder cover.
HINWEIS:
boards.
HINWEIS:
is replaced, run the
Drop detect spittoon
Replace the drop detect spittoon at the scheduled preventive maintenance interval.
HINWEIS:
and consumables" auf Seite
ACHTUNG:
„Sprüherkennungsbehälter" auf Seite 668
HINWEIS:
Reset the preventive maintenance counter for this item every time maintenance is performed.
98 Kapitel 4 Managing and maintenance
If the error code "C6.0B02 - Device due for maintenance" has occurred with SNMP status
Do not use any liquids to clean the drum encoder disk. The disk must be wiped only with
If available, use compressed air to clean these areas.
To correct an existing encoder mounting gap, unscrew the encoder cover (one screw)
Ensure all three encoders and covers are mounted flush to their respective circuit
When either the Drum Encoder Averager PCA (EN1) or the Drum Encoder PCA (EN2)
„Drum Position calibration" auf Seite
Dispose of all wet material as appropriate. See
26.
Use gloves and safety glasses when handling ink parts.
The drop detect spittoon incorporates two bonding agent duct wipes.
140.
„Handling and disposing of service parts
DEWW