HP CM8060 Color MFP Kundendienst Handbuch Seite 130

6. Vertical Magnification adjustment
a. Measure the copied page from point A to D. If the measured value is 127 mm ± 1 mm (5.0 in
± 0.04 in), skip to the Leading Edge adjustment.
b. Touch the Vertical Magnification field to select it.
c. Using the keypad, enter the measured value.
d. Touch Enter to update the setting.
e. Load the original again.
f. Touch Single-Sided to make another copy and confirm the Vertical Magnification
adjustment.
7. Leading Edge adjustment
a. Measure the distance from the top edge of the paper to point F. If the measured value is 20
mm ± 2 mm (0.79 in ± 0.08 in), skip to the Single-sided Centerline adjustment.
b. Touch the Leading Edge Adjustment field to select it.
c. Using the keypad, enter the measured value. Press Enter.
8. Centerline Simplex adjustment
a. Measure the distance from the left edge of the paper to point E. If the measured value is within
the following specification, skip to Confirm adjustments.
Target page size
Dimensional Image Quality 11x17
Dimensional Image Quality A3
Dimensional Image Quality 8.5x11
Dimensional Image Quality A4
b. Touch the Centerline Adjustment field to select it.
c. Using the keypad, enter the measured value.
d. Touch Enter to update all the settings. (Entering a 0 (zero) value does not change a setting.)
9. Confirm adjustments
a. Place the printed target page face up in the ADF input tray with the top edge of the page
facing left.
b. Touch Single-Sided and confirm all adjustments.
10. Centerline Duplex Front
a. Place the printed target page face up in the ADF input tray with the top edge of the page
facing left.
b. Touch Double-Sided.
64 Kapitel 3 Copier Diagnostic Field Tool (CDFT)
ADF centerline specification (Simplex or Duplex)
139.7 mm ± 2 mm (5.5 in ± 0.08 in)
148.5 mm ± 2 mm (5.85 in ± 0.08 in)
107.9 mm ± 2 mm (4.32 in ± 0.08 in)
105 mm ± 2 mm (4.13 in ± 0.08 in)
DEWW