Tray 2, 3, and 4 adjustments
Tray 2, 3, and 4 pick arm alignment
When installing the pick arm assembly, do not tighten the three screws at the rear of the assembly until
you install the associated tray in the Trays 2, 3, and 4 assembly. When the pick arm lowers after the
tray is installed, push the pick arm roller against the tray edge, and then tighten the screws.
For instructions on removing the pick arm assembly, see
154 Kapitel 5 Calibrations and adjustments
„Einzugsarmeinheit" auf Seite
330.
DEWW