HP CM8060 Color MFP Kundendienst Handbuch Seite 95

Log into the EWS
The remote access service password for the EWS is the same as the remote access service password
for the MFP control panel. A service password must be configured at the control panel before service
personnel can access the EWS.
TIPP: For more information on how to set up the service password for the MFP, see
access password (CDFT-E only)" auf Seite 71
1. Open the EWS and click Log In in the upper-right corner of the screen.
The Enter Network Password dialog box appears. The appearance of the login screen can vary,
depending on your operating system and browser.
2. Type service for the user name, type the service password, and then click OK.
Log off the EWS
1. Click Log Off in the upper right corner.
2. Close the browser.
HINWEIS:
XDM (XML Device Model)
XDM (XML Device Model) is an HP proprietary specification that is used to store machine data and
configuration information such as error and warning logs, preventive maintenance counters, page
counts, and others. XDM can be accessed remotely through the e-mail notification and HP Instant
Support features. The data can be used to remotely diagnose machine failures and predict preventive
maintenance needs.
An XDM viewer application is provided to simplify viewing of the XDM data. The XDM viewer is available
on the service support Web site.
The XDM content varies by user type. For the service user, service information such as the Warning
log and the Preventive Maintenance information is included. No customer private data is available in
the service contents of the XDM, and no service information is available in the administrator or user
contents of the XDM.
TIPP: See the system administrator guide for more information about user types and the EWS.
E-mail notification features
E-mail notification is supported by the Alerts and AutoSend features.
These features require the configuration of the Notification Server in the EWS. The Notification Server
should be configured by the customer or system administrator. Service users should always test their
Alert and AutoSend configurations using the Test button. If the test does not result in an e-mail message
sent to the configured e-mail address, the service person should request that the customer configure
the Notification Server.
TIPP: See the system administrator guide for more information about e-mail notification features.
DEWW
It is important to completely terminate the connection by closing the browser.
Remote support and embedded Web server (EWS)
„Set the remote
29