HP CM8060 Color MFP Kundendienst Handbuch Seite 138

Calibrate the HP Multifunction Finisher
To gain access to calibrations in CDFT, click Settings/Procedures, and then click Calibrations.
●
Accumulator offset alignment
●
Stapler alignment
● Set the finisher stapler 2 paper-size setting
For a full description of a calibration, see
Accumulator offset alignment
1. Click Settings/Procedures.
2. Click Calibrations.
3. Click Offset stall.
Stapler alignment
1. Perform the Accumulator offset alignment.
2. Click Settings/Procedures.
3. Click Calibrations.
4. Click Finisher Stapler.
5. Click Letter or A4 to print a sample test page. The test page shows the desired position for the
staples.
6. Click < or > to reposition the staple left or right. The offset value in millimeters is displayed.
7. Click Set to commit the change.
Set the finisher stapler 2 paper-size setting
HINWEIS:
letter-size position. See the installation guide for information on changing the stapler 2 position.
1. Click Settings/Procedures.
2. Click Paper Size Settings.
3. Click < or > to change the finisher paper-size setting to A4 or Letter (the setting must match the
physical stapler 2 installed position).
4. Click Commit Change to save the stapler 2 paper-size setting.
HINWEIS:
turned off, and then on.
72 Kapitel 3 Copier Diagnostic Field Tool (CDFT)
Before setting the stapler position, look at stapler 2 and verify if it is installed in the A4- or
The finisher stapler 2 paper-size setting does not take effect until the MFP power is
„Calibrations and adjustments" auf Seite 135.
DEWW