HP CM8060 Color MFP Kundendienst Handbuch Seite 113

Start using CDFT
● How to start CDFT-L
● How to start CDFT-E
HINWEIS:
How to start CDFT-L
Follow these steps to start CDFT-L:
HINWEIS:
1. Connect a LAN cable from the laptop to the MFP LAN port.
HINWEIS:
information, see
2. Turn on the power to the MFP and wait for the system to initialize.
3. Start the CDFT-L application from the laptop.
4. When prompted, type the remote access password in the Password field and click OK.
HINWEIS:
(CDFT-E only)" auf Seite
If you have trouble connecting directly to the MFP with CDFT-L, see
von CDFT-L" auf Seite
How to start CDFT-E
To start CDFT-E from the MFP control panel:
1. Touch Service on the control panel home screen.
2. Select the language you want.
HINWEIS:
3. Enter the Service PIN, and then touch OK.
Options available in CDFT-L, CDFT-E, Service Assist Mode, and Protected
Service Mode (PSM)
This table summarizes options available in CDFT-L, CDFT-E, Service Assist Mode, and Protected
Service Mode (PSM).
Function
Run motors, solenoids
Test voltages
Change remote service
password
Deductive page view
DEWW
To start a service assist call, see
Wireless must be turned off before connecting to the MFP in order to use CDFT-L.
If you need to perform an RFU, use a USB cable to connect to the MFP. For more
„Use CDFT to perform an RFU" auf Seite
The remote access password is set in CDFT-E. See
71.
1108.
This step is only required when accessing full service mode for the first time.
CDFT-E (non-PSM)
X
X
X
„Use service assist mode" auf Seite
56.
CDFT-L (non-PSM) PSM
X
X
X X
53.
„Set the remote access password
„Probleme beim direkten Anschluss
Service Assist Mode
X
Introduction 47