HP CM8060 Color MFP Kundendienst Handbuch Seite 232

HP Multifunction Finisher calibrations
●
Stapler alignment
●
Accumulator offset alignment
●
Stapler 2 paper-size adjustment
Stapler alignment
Purpose
This calibration adjusts the relative position of the staples from stapler 1 and stapler 2 on the media.
When to run
Run this alignment if staples are out of position on a print job.
Required time
2 to 3 minutes
Internal operation
The alignment adjusts the relative position of the staples by increasing or decreasing the spacing
of the staple from the edge of the media
Instructions
▲ See „Stapler alignment" auf Seite
Accumulator offset alignment
Purpose
This calibration aligns the accumulator offsetters.
When to run
Run this calibration after replacing the Finisher Main PCA (A200), an accumulator offset motor
(M244 or M245), or the accumulator assembly.
Required time
2 to 3 minutes
Internal operation
The alignment adjusts the relative position of the accumulator offsetters.
Instructions
▲ See „Accumulator offset alignment" auf Seite
166 Kapitel 5 Calibrations and adjustments
72.
72.
DEWW