Closing The Canopy; Trimming The Controls - Reely Speedy Mania Bedienungsanleitung

g) Closing the canopy
After checking the drive and steering functions, be sure to put the canopy on before putting the model boat in the
water.
Put the canopy correctly on the model boat. Turn the locking knob (1) on the underside of the hull by 180°. Then turn
the four locks (2) on the top by 90° backwards as shown in the figure.
Make sure that the four locks are at a 90° angle to the hull before putting on the canopy, as shown in Figure
9. Do not use force when putting on and locking the canopy.
h) Trimming the controls
Adjusting the drive trim
If the motor still runs when the throttle trigger switch (Figure 1, no. 3) is in the middle (neutral) position, this can be
corrected with buttons "B" and "F" of the drive trim "TH/TRIM" (Figure 2, no. 7).
Adjust the drive trim so that the motor does not turn when the throttle trigger switch is in the middle (neutral)
position.
The transmitter emits a short beep each time a button is pressed. A long beep indicates either the middle position of
the trim or the end position.
Adjusting the steering trim
If the model boat tends to deviate slightly to the left or right when moving straight, this can be balanced with buttons
"R" and "L" of the steering trim "ST/TRIM" (Figure 2, no. 8).
If the model boat deviates to the left, press the "R" button. If the model boat deviates to the right, press the "L" button.
The transmitter emits a short beep each time a button is pressed. A long beep indicates either the middle position of
the trim or the end position.
Figure 9
47